CM 902 - 3 Tone Brown

3 Tone Brown
Code : CM 902

Diameter : 14.00 mm
Base curve radius : 8.40 - 8.60 mm
C.T. : 0.04 - 0.13 mm
Water content : 38 - 42 %
Power range : 0 - 10.00

CM 903 - 3 Tone Green

3 Tone Green

Code : CM 903

Diameter : 14.00 mm

Base curve radius : 8.40 - 8.60 mm

C.T. : 0.04 - 0.13 mm

Water content : 38 - 42 %

Power range : 0 - 10.00

CM 904 - 3 Tone Blue

3 Tone Blue
Code : CM 904

Diameter : 14.00mm
Base curve radius : 8.40 - 8.60 mm
C.T. : 0.04 - 0.13 mm
Water content : 38 -42 %
Power range : 0 - 10.00

CM 905 - 3 Tones Purple

3 Tone Purple

Code : CM 905

Diameter : 14.00 mm

Base curve radius : 8.40 - 8.60 mm
C.T. : 0.04 - 0.13 mm

Water content : 38 - 42 %

Power range : 0 - 10.00

Geo Medical Cosmetic Lens

GEO Magic Colour

Soft Contact Lenses are indicated for daily wear to correct visual acuity in aphasic and not aphasic persons with non-dieseased eyes with myopia or hyperopia.

The lens may be worn by persong who exhibit refractive astigmatism of 0.50 diopters or less where the astigmatism does not interfere with visual acuity. The lens is available clear or tinted and may be used to enchance or alter the apparent colour of the eye.

Geo Company History

1 to 3 tones


Magic Circle Lens



Animation & Crazy Lens

Message / Character / Constellation Lens

Caring for Lens and Lens Case

Fore the continued safe and comfortable use of your lenses, it is important to follow the instructions given to you by your Eye Care Practitioner.
Failure to follow the correct lens care regime may result in the development of serious eye problems.
Cleaning and rising are essential to remove mucus, secretions, and deposits which may have accumulated during use. Do this immediately after removing you lenses and prior to disinfection. Harmful germs can only be removed by cleaning, rising and disinfecting.

• Use fresh, unexpired lens care solutions.
• Never use solutions recommended for conventional hard lenses only.
• Never put your lenses in your mouth or use anythings other than the recommended solutions for lubricating or wetting your lenses.
• Never rinse them in tap water, since this can contain many impurities that can contaminate or damage your lenses and may lead to eye infection or injury.
• Put each lens into the correct chamber of the lens storage system and make sure they are completely immersed in the storage solution when they are not being worn. If lenses left out for long periods, they may dry out and become brittle.
• Seek the advice of your Eye Care Practitioner if your lenses are to be stored for extended periods.
• Since lens cases can be a source of bacteria, after use they should be emptied, cleaned and rinsed with recommended sterile solutions and allowed to air dry.
• Your lens case should also be replaced regulary, as advised by the lens case manufacturer or your Eye Care Practitioner.
• Never use tap water ro rinse your lens case.
  

Instruction for Use

• Never wear lenses longer than the period prescribed.
• Do not use the lens if the sterile package has been opened or tamper evident seal is damaged.

Insertion of Lens

To avoid mix-ups, develop the habit of always inserting the first lens in your right eye. Before inserting the lens, check to see it is free or any nicks or tears. If it appears damaged, throw it away. Check the lens has not turned inside out. Place the lens on the top of your forefinger aand hold above eye level ; you are looking at the bowl of the lens from outside.

• Remember to start with your right eye. Once the lens has been examined and you are sure it is not insde out, place it on the tip of your forefinger.
• Place the middle finger of the same hand close to your lower eyelashes and pull down the lower lid.
• Use the forefinger or middle finger of the other hand to lift the upper lid and place the lens on the eye.
• Gently release both lids and blink.
• Repeat these steps for the left lens